______ 
| ___ \
| |_/ /
|    / 
| |\ \ 
\_| \_|
       
       

  _   _ 
 | \ | |
 |  \| |
 | . ` |
 | |\  |
 |_| \_|
        
        

 _    _ 
( )  ( )
`\`\/'/'
  >  <  
 /'/\`\ 
(_)  (_)
        
        

  ###    
   ##    
   ##    
   ##    
   ##    
   ##    
  ####   
         

   ##    
   ##    
 ######  
   ##    
   ##    
   ##    
    ###  
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
4/6-09 Matches for Daniel The problem is solved. As we have seen many times Mt can not always write the correct values into the processor, thus giving a false H2 Table After that was corrected in Table and uploaded to the processor it seemed the ignition worked as it should and the car drove well. *Can VemsTune correct the H2 table? Ore is et a problem there can not be solved (using 1.0.73 and Mt) Tnx Peter ---- Hello, we just installed Vems 3.5 firmware 1.0.73 on a Toyota 5efte engine. We are running multitooth on a 12-1 wheel in the distributor. Our big problem is that we only have spark on cylindre 1 and 4. The two others we dont have any spark. Do anyone know how to get all the sparks out to one coil?! Here are our config: Ignition Settings: Outputs in use: 00 Only Ignition driver type: DUMMY Dual output mode: Disabled. we tryed to enable it Ingnition output in use: 00 Only 0: 7 Pin 10 Primary Triggersettings: Edge: Rising Type: Multitooth Filtering: Disabled TDC: 100deg Number of teeth: 11 triggertooth: 3 Next: 6 Any Help???
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.