_   _ 
 | \ | |
 |  \| |
 | . ` |
 | |\  |
 |_| \_|
        
        

 ______  
(  __  \ 
| (  \  )
| |   ) |
| |   | |
| |   ) |
| (__/  )
(______/ 
         

###      
 ## ###  
 ## #    
 #####   
 ## ##   
 ##  ##  
#### ### 
         

 _       _ 
( )  _  ( )
| | ( ) | |
| | | | | |
| (_/ \_) |
`\___x___/'
           
           

 _______ 
(_____  )
     /'/'
   /'/'  
 /'/'___ 
(_______)
         
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
I am installing VEMS V 3.5 fw: 1.0.73 on a Toyota Celica 3sgte. Everything is fine, except some trigger errors. We have used the 24 tooth OEM trigger wheel where we have removed 2 teeths, so we are going 12-1. The car starts and runs perfect up to 4200rpms. When we reach 4200 rpms the car strumbles and backfires. Here is our trigger config: Tooths on wheel: 11 Degress before TDC 50 Trigger tooth: 1 Next Trigger 6 And of course Whelldecoder on. Whe have tryed to: Switch the two wires. Larger and smaller gap between the sensor and wheel. Removed the 10.3 K ohm pullup resistor on the board. Used a new shielded cable between sensor and vems. Tryed to add a 800 ohm resisor on signal wire and ground. But nothing helps. Here are a scope log when the problem acting: http://www.vems.hu/files/MembersPage/Daniel/Celica%20ST202%203sg(T)e%20gt35/Omdrejningsføler%202%20målt%20på%20stel%20også%20fra%20giver%2012-1%20Trigger%20fejl%20ved%204100rpm.gif I Think it looks ok! And the MSQ file http://www.vems.hu/files/MembersPage/Daniel/Celica%20ST202%203sg(T)e%20gt35/Klaus%20celica%203sgte%2012-1%20440cc%20dyser%20gt35.msq We took a scope log of the ignion setup also ( OEM Igniter ): http://www.vems.hu/files/MembersPage/Daniel/Celica%20ST202%203sg(T)e%20gt35/Igniter%20signal%20virker.%20Med%20lus%20over%20udgang,%20ikke%20inverted.gif Thanks for your time!
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.