_____ 
 | ____|
 |  _|  
 | |___ 
 |_____|
        

______ 
| ___ \
| |_/ /
|  __/ 
| |    
\_|    
       
       

 ___   
(  _`\ 
| (_(_)
|  _)  
| |    
(_)    
       
       

         
 ##      
 ##      
 #####   
 ##  ##  
 ##  ##  
 ##  ##  
         

______ 
| ___ \
| |_/ /
|  __/ 
| |    
\_|    
       
       

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
Hello, we are planing to build one of our private cars whit vems. Our goel is to make a PnP install. Q: Our only concern is about the trigger! Our car is driving whit a 4 + 1 trigger system. The 4 triggers comes 10 degress before TDC, and the cam sensor trigger comes in TDC for cylinder one.. Is that posible ? A: This trigger is easy, but you must use VemsTune to make a triggerlog and check the timing of the primary and secondary trigger pulses. The cam sync must always appear between the same two primary trigger events, if not then you will see "sec trigger late/early" in VemsTune and datalogs. You can try offsetting the signal using the trigger edge setting for both or either of the triggers, change from falling/rising to the other will offset the signal by a trigger tooth width. //Mattias Kind Regards Daniel
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.