/\    
    /  \   
   / /\ \  
  / ____ \ 
 /_/    \_\
           
           

  ###    
   ##    
   ##    
   ##    
   ##    
   ##    
  ####   
         

 ___   
(  _`\ 
| (_(_)
`\__ \ 
( )_) |
`\____)
       
       

  _  __
 | |/ /
 | ' / 
 |  <  
 | . \ 
 |_|\_\
       
       

         
         
  ####   
 ##  ##  
 ##      
 ##  ##  
  ####   
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
With this solution you can fast open low z injectors and fast close(30V flyback) but with 25% pwm(low energy losses on flyback transistor). Hold time is 1ms. Schematic: http://carphotos.cardomain.com/ride_images/1/2822/1741/7053370240_large.jpg * we are thinking to use '''MTD20P06LG (ONS) RoHS P-POWERFET 60V 20A DPAK''' - any objections ? * diode: MBRB20100CT (in stock at lomex, D2PAK, 83.50 ft each) * diode : I use by500-1000 (cheap, fast) ** I put zener diode on vems board 30V transient protection diode (1k5E30 diode from WebShop) ** so when pwm is activated, current flow through active flyback, but when injector needs to close, 30V high voltage flyback inside VEMS does the clamping Same schematic, but drawn in a slightly confusing way: http://img359.imageshack.us/img359/5412/flybackln2.jpg When pwm last, flyback voltage is 0.3-1.5V(depending of schottky diode and mosfet(irf9540)) http://img516.imageshack.us/img516/5109/voltagevs1.jpg Bad thing is, you must have one of thise flyback for every injector. PCB http://hosting01.imagecross.com/image-hosting-07/49841.jpg Assembled board(missing 2 zener diodes, i bought two too few) http://hosting01.imagecross.com/image-hosting-07/4062.jpg That board was tested on lpg injectors(landi renzo, 0.9ohm) and working well. ----- Hi, could you please share the LPG injector setting you used? What is the max output these can handle? Whats the minimum opening time?Whats the max allowed Duty? Thanks, Peter
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.