___   
(  _`\ 
| ( (_)
| |  _ 
| (_( )
(____/'
       
       

  ###    
   ##    
   ##    
   ##    
   ##    
   ##    
  ####   
         

         
         
 ##  ##  
 ##  ##  
 ##  ##  
  #####  
    ##   
 ####    

         
#### ### 
 ##   #  
  ####   
  ###    
 #  ##   
###  ### 
         

   ___  
  / _ \ 
 | | | |
 | |_| |
  \___/ 
        

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
'''0.8L inline 3 cylinder, SOHC 6 valves, MPFI system, manual transmission''' 4 IGBT good choice ? '''Primary trigger ?''' * VR (most likely, Sounds like HALL, from the description but HALL, VR is unbelievable combination). 60-2 '''Secondary trigger''' * VR ---- - coil near plug distributorless system – 1 coil per each plug - ECM has an ignition module for the coils - PWM IAC valve - sequential injection - MAP sensor (no MAF) - '''magnetic''' (???) '''crankshaft position sensor'''; the sensor protrudes through its mount to within approximately 1.3 mm (0.05 inch) of the crankshaft reluctor. The reluctor has 58 slots machined into it, 57 of which are equally spaced in 6-degree intervals. - '''Camshaft sensor is VR type'''; reading is not made directly from a camshaft reluctor, instead it has a separate camshaft lug (1X type) that sits on the opposite site of the cam gearing. - IAT sensor with open element - ECM controls fans and A/C system Stage 2 build: - stainless steel exhaust manifold, 35 mm runners, ceramic coated - custom built Garrett T2 hybrid with billet intake wheel - stainless steel 50 mm turboback + 35 mm screamer pipe - aluminum intercooler piping (50 mm) - single disk ceramic clutch with modified pressure plate - 250 cc injectors @ 3 bar - stock engine, gearbox, intake manifold and throttle body (45 mm) - ready for VEMS install Stats (figures at the crank) Stock NA: 48 HP and 68 NM Stage 1: 80 HP and 113 NM @ 0.4 bar Goal for stage 2 with these injectors is to reach 100 HP
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.