__  __ 
 |  \/  |
 | |\/| |
 | |  | |
 |_|  |_|
         

         
         
 ##  ##  
 ##  ##  
 ##  ##  
  #####  
    ##   
 ####    

 _____ 
|_   _|
  | |  
  | |  
 _| |_ 
 \___/ 
       
       

 __        __
 \ \      / /
  \ \ /\ / / 
   \ V  V /  
    \_/\_/   
             

 ___   
(  _`\ 
| (_) )
|  _ <'
| (_) )
(____/'
       
       

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
'''Trigger related page for MembersPage/DTechnologies/Hayabusa project''' I need to configure the firmware for my engine. '''Basic info''' * '''... cyl''', even fire, fire order: .... * '''crank and cam triggers involved''' - both are variable reluctance sensors. The 2nd LM1815 bought separately (only 1 LM1815 is populated by default) is already mounted on board (?). ---- '''Crank trigger''' * there are 8 equidistant teeth on the crank * positions: ... I don't know the timing yet ---- '''Cam trigger''' * single tooth (natch) * timing: I don't know the timing yet ---- '''How do I figure out the timing?''' - with the least amount of fuss We usually remove a sparkplug, and move the car in gear 5 until the given engine is at TDC. Than look at the trigger wheels. There are often marks on the crankwheel (that can be at TDC or other position in custom-hacked setups) This is something I've been fearing. I've had the engine apart but I can't determine anything that way because the sensors themselves are mounted inside the covers (valve cover & stator cover). At best I'd only be able to guess how many degree's forward or back they are of the tooth/teeth. ---- '''How to I set up the firmware appropriately?''' The bad news is that current firmware does not support this crankwheel directly, unless engine is a 16cyl. '''Options:''' * bolt on another wheel, eg. 12-1 (or 36-1 or 60-2). Feasible ? ** 2003 Hayabusa uses a 24-1 wheel. The wheel is also the magnet wheel for the generator...so it's a bit expensive. The search for a used one has been going on for months. ** Aftermarket options are available. Fast by Gast makes a 2 magnet trigger wheel which is driven by starter gears. Requires entire starter housing to be replaced with custom assembly cnc'd out of billet aluminum...even more expensive unfortunately. * grind off 1 tooth from crank to get a 8-1 multitooth wheel ** Teeth are very wide. This would definately cause balance issues. * firmware modification: feasible, but significant table-testing needed ** Considering my inexperience, this might not be the best path. * Adding a magnets to the wheel and using an aftermarket sensor?
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.