####  
  ## #   
  ##     
 #####   
  ##     
  ##     
 ####    
         

   ____ 
  / ___|
 | |    
 | |___ 
  \____|
        

         
         
 ##  ##  
 ####### 
 ## # ## 
 ##   ## 
 ##   ## 
         

 __      __
 \ \    / /
  \ \  / / 
   \ \/ /  
    \  /   
     \/    
           
           

  ____  
 |  _ \ 
 | |_) |
 |  _ < 
 |_| \_\
        

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
'''Certified CNG engine''' 4 cyl engine ---- '''Certification''' There are some considerations for certification (R110 ?) Eg. EMI: most likely series resistors will be used, not PWM-ing (with PWM-ing, special harness would be needed to pass certification EMI test). The Certification harness might slightly differ from the production harness. Eg. * contains signal generator for primary trigger * might be slightly shorter Why certify ? Third-party certification is good for certification :-) ---- '''Trigger''' * primary trigger: VR (?) ** pattern ? * secondary trigger: VR (?) ---- '''Low Impedance Injectors''' [http://enerma.pl/en/injectros/3898-injector-hercules-gism-i1000-bf.html Hercules GISM-I1000] '''3.8 Ohm measured, some sites say 1.7 Ohm''' * Opening time - 2.5 ms * Operating temperature - 20 ° C (or -40C) to +120 ° C * no PWM-ing (especially for certification harness) 3.3 or 4.7 Ohm 50 Watt series resistor for each ? (6.8 Ohm might be too high to open reliably). ---- '''Pressure sensors''' '''MAP sensor on "air-side" * BOSCH 10-07-133-FL1 816 0261230042 ** is this in manifold ? * CNG pressure senzor: '''BOSCH 0 261 230 145''' ** 0-5V analog signal ? ** What is the CNG pressure regulated or pressure compensation needed ? ** What is CNG pressure ? (or what is the pressure range ?) ---- '''Harness for certification''' * 1 or 4 injectors ? * signal generator * can TUV apply 13.5V (12..14V) DC supply ** or should we include a 230V => 12V supply with the test setup ?
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.