|\     /|
| )   ( |
| |   | |
( (   ) )
 \ \_/ / 
  \   /  
   \_/   
         

      ## 
  #####  
 ##  ##  
 #####   
  ##     
  #####  
 ##  ##  
 #####   

 __        __
 \ \      / /
  \ \ /\ / / 
   \ V  V /  
    \_/\_/   
             

         
         
  #####  
 ##      
  ####   
     ##  
 #####   
         

 _______ 
/ ___   )
\/   )  |
    /   )
   /   / 
  /   /  
 /   (_/\
(_______/
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
TVR Cerbera fitted with AMG M113.980 v8 engine 5500cc. ECU: VEMS 3.6. Firmware 1.1.96 '''Sensors:''' * MAP: vems internal sensor. * IAT: as sold on vems website. * Coolant: bosch * TPS: nissan * Lambda: 1x bosch wideband * Trigger: Bosch VR part number 0241210171 ** no shield on wire. using original engine loom. ---- '''Sectrig:''' * ECU was configured factory sectrig=VR ** home-conversion to sectrig=HALL was attempted, but '''NOT GOOD YET''' * measured 0.37 volts on EC36/17 HALL input when nothing connected ** that is too low ! Should be 3.7V or higher (min 3.0V, realy !) at EC36/13 (or the CPU side of SJ7) * '''REMOVE THE WIRE EC36/13 to the board''', that goes to the 10k before LM1815/pin3 * see the v3.6 sectrig=HALL on GenBoard/Manual/InputTriggerHardWare (v3.6 == v3.7) Bosch Hall HA-P2 part number 0232103111, no shield on wire. Sectrig working well after following above page. ---- Ignition: -8 x coils direct drive from ECU Bosch twin single fire coil 2x1 part number 0221503035 2k ohm in plug leads. all on seperate channels from ecu Injectors: -8 x Standard Bosch for this engine high impedence 13ohms. all on seperate channels from ecu. Outputs: -Fuel pump relay -cooling fan relay -IAC Bosch double solinoid. running on stepper outputs. Timing: crank trigger 60-2. missing tooth at 65 deg btdc. fire order 1-5-4-2-6-3-7-8 TODO: knock settings. runing 2 bosch twin wire sensors. no shield on cable to GND. one wire from each goes to EC18/1 and EC18/2 and both are grounded to EC18/17. is this ok? main problem is software settings, what do i put for (knock chan)? no help menu on vems tune for this. all other input values make sence. many thanks. Contact: curlyracer atbutnossppam hotmail.co.uk
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.