/'\_/`\
|     |
| (_) |
| | | |
(_) (_)
       
       

         
  ####   
 ##  ##  
 ##  ##  
 ##  ##  
 ##  ##  
  ####   
         

         
         
 #     # 
 #  #  # 
 #  #  # 
 #  #  # 
  ## ##  
         

  _____ 
 |_   _|
   | |  
   | |  
   |_|  
        

 #       
 #       
 #   #   
 #  #    
 # #     
 ## #    
 #   #   
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
TVR Cerbera fitted with AMG M113.980 v8 engine 5500cc. ECU: VEMS 3.6. Firmware 1.1.96 '''Sensors:''' * MAP: vems internal sensor. * IAT: as sold on vems website. * Coolant: bosch * TPS: nissan * Lambda: 1x bosch wideband * Trigger: Bosch VR part number 0241210171 ** no shield on wire. using original engine loom. ---- '''Sectrig:''' * ECU was configured factory sectrig=VR ** home-conversion to sectrig=HALL was attempted, but '''NOT GOOD YET''' * measured 0.37 volts on EC36/17 HALL input when nothing connected ** that is too low ! Should be 3.7V or higher (min 3.0V, really !) at EC36/13 (or the CPU side of SJ7) * '''REMOVE THE WIRE EC36/13 to the board''', that goes to the 10k before LM1815/pin3 * see the v3.6 sectrig=HALL on GenBoard/Manual/InputTriggerHardWare (v3.6 == v3.7) Bosch Hall HA-P2 part number 0232103111, no shield on wire. Sectrig working well after following above page. ---- Ignition: -8 x coils direct drive from ECU Bosch twin single fire coil 2x1 part number 0221503035 2k ohm in plug leads. all on seperate channels from ecu Injectors: -8 x Standard Bosch for this engine high impedence 13ohms. all on seperate channels from ecu. Outputs: -Fuel pump relay -cooling fan relay -IAC Bosch double solinoid. running on stepper outputs. Timing: crank trigger 60-2. missing tooth at 65 deg btdc. fire order 1-5-4-2-6-3-7-8 All running perfect although not managed to setup knock sensors yet... in need of a dyno! Contact: curlyracer atbutnossppam hotmail.co.uk
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.