___  
  / _ \ 
 | | | |
 | |_| |
  \___/ 
        

 _______ 
(  ____ \
| (    \/
| |      
| |      
| |      
| (____/\
(_______/
         

  _____ 
 |  ___|
 | |_   
 |  _|  
 |_|    
        

 _____ 
|  __ \
| |  \/
| | __ 
| |_\ \
 \____/
       
       

         
  ####   
     ##  
  #####  
 ##  ##  
 ##  ##  
  ### ## 
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
The engine is a bmw s50b32 converted to single vanos on intake with a trigger with one tooth installed at ~60 degree before missing tooth, the vems trigger log also shows this. The ecu is unit 7148, vr vr and 4 pfet for vanos control The car runs perfect in wasted spark mode. Is making 806hp at 7700rpm and 1.5bar boost. Now I'm trying to make vanos work on intake so I can make boost faster, now I see 1bar at 5000rpm. Vanos is working good from the logs I made but I have problems with the secondary trigger. When cranking the signal is very good and stable, the problem is when I start the engine. I have to many sectrig and I can't rev past 1300, the ecu seams to reset as the afterstart flag comes on. I tried to play with the filter settings (minimum angle 39, maximum 120) and i manage to filter it a little and now i receive only sectrig pos bad and the engine revs, as you can se in the logs at ~4000+rev the trigger error is gone!!! I made the following: - Changed the sensor.Same result - Changed the sectrig wiring, completely separate from the engine wiring, from the sensor strait to the ecu, Same result - Changed the polarity of the sectrig. the signal moved to the second tooth after the missing tooth and the logs shows ~350 degrees. This was wrong because the trigger was installed at ~60 ( 9 tooth before missing tooth )... anyway with the polarity change same sectrig errors - I changed the vems ecu with a similar one ( vr vr ). same result - I use a oscilloscope to see if the signal has noise or something. The signal is good, a little noise when cranking but good signal when the engine starts. - I tried and pull the sensor out ~1mm and got less errors and manage to rev the engine to ~2500rpm with no filters , if i try to pull the sensor more than 1mm the sectrig signal is gone. - I started with firmware 1.1.96, with this firmware the car worked for a few years with the old ecu without the pfets. Now i have firmware 1.2.11 I will try to look again at the wiring, grounds and maybe rewire the crank and cam triggers!!! I don't know what "ignore sectrig pulses above" and "maximum primary edge between secondary edges" does?!?! How should i configure this settings??? Please let me know if you have any ideas
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.