____  
  / __ \ 
 | |  | |
 | |  | |
 | |__| |
  \____/ 
         
         

 _       _ 
( )  _  ( )
| | ( ) | |
| | | | | |
| (_/ \_) |
`\___x___/'
           
           

 _   _ 
( ) ( )
| `\| |
| , ` |
| |`\ |
(_) (_)
       
       

         
  ####   
 ##  ##  
 ##  ##  
 ##  ##  
 ##  ##  
  ####   
         

         
         
  ### #  
 #   ##  
 #   ##  
  ### #  
      #  
      #  

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
Hi I am working on a BMW 635 csi '79 ---- I am going full sequential ignition and injection The input triggers: original 60-2 wheel (BMW e34 ’90) Camsync: [http://www.cy-sensors.com/Vane%20Sensors.pdf Hall-Effect Vane sensor] Camsync sensor position with the info on GenBoard/Manual/InputTriggerCamSync I made the following drawing to figure out where the camsync must be placed http://www.spads.com/uimages/campuls.JPG This image doesn't load for me ... let's try: http://www.spads.com/uimages/campuls.jpg See DocsPage bottom for file area. So if i turn the crankshaft to 150 degrees before TDC of cilinder 1 the Hall sensor mounted on the camshaft should give a reset puls. Please correct me if I'm wrong -----------------------------------------------------------------
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.