__      __
 \ \    / /
  \ \  / / 
   \ \/ /  
    \  /   
     \/    
           
           

         
         
  ####   
 ##  ##  
 ######  
 ##      
  #####  
         

 __      __
 \ \    / /
  \ \  / / 
   \ \/ /  
    \  /   
     \/    
           
           

    #    
 ######  
   ##    
   ##    
   ##    
   ## #  
    ##   
         

         
         
  ####   
 #    #  
 #    #  
 #    #  
  ####   
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
'''Audi AAN 5cyl 20VT engine''' Modifications: Eurospec 2.6L Block (Carillo rods, Arias pistons) ported and polished/flow matched cylinder head GT30R .82 A/R Turbo (4" anti-surge inlet) 60 lb/hr Injectors w/ Bosch 044 Fuel Pump Stromung 3" exhaust w/ custom 3" downpipe RS2 exhaust manifold Greddy Oil Catch Can Samco boost hoses Apikol Gen.2 Intercooler custom charge pipe w/ HKS SSQV blow-off valve 034 Motorsports High Output Coil Kit RS2 6-speed transmission South Bend FE Series Clutch JB Racing 11 lb. flywheel 2Bennett full coilover suspension (track spec) OZ Racing Ultraleggera 17" x 8" wheels Porsche 996TT brakes Please measure the MAF pins in the harness * which AANpin it belongs to (fill in table below) * any pin connected to ground must be avoided. * Is there a +12V pin (capable of 2..3A) for heater+ ? We recognized that the MAF connector is simply unsuitable, because we need 4 pins (neither must be connected to GND or +5V) which is simply not available in the MAF connector. If we find 3, that, together with the NBO2 nernst signal might be enough. Anyway, finalized pins to use for WB02 LSU4 sensor: * AANpin...#42 (open on stock harness) pump- * AANpin...#37 (+12V supply-flyback, voltage supplied by the AAN harness, NOT the ECU like on the 3B) * AANpin...#43 (open on stock harness) nernst * AANpin...#51 (open on stock harness) pump+ * AANpin...#54 (open on stock harness) heater- * not used Using these pins we wouldn't use the MAF plug, but would allow there to be enough inputs for the WB02. ---- In the meantime, review VemsAudiAan You can do the verification measurements,
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.