##  
         
    ###  
     ##  
     ##  
 ##  ##  
 ##  ##  
  ####   

  __  __ 
 |  \/  |
 | |\/| |
 | |  | |
 |_|  |_|
         

         
  ###    
   ##    
   ##    
   ##    
   ##    
  ####   
         

 __   __
 \ \ / /
  \ V / 
   > <  
  / . \ 
 /_/ \_\
        
        

 _______ 
(  ____ )
| (    )|
| (____)|
|  _____)
| (      
| )      
|/       
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
:::::>>>>Questions<<<<::::: '''Last time''' I pulled my VEMS out and played with it '''I managed to get it stuck in bootloader: in the 19200 baud I got "AVREFI1" output'''. I didn't play with it too much after that and put it back in its case and back into storage. Now just as of recent I've pulled it back out and really started to get back to work on it and I can't reproduce anything. I've checked over my serial connections. Describe, how. * What cable do you use? * What "com-port" is it ? * Did you the do a successful pin2-pin3 loopback test ? (loopbacking the cable connected to the PC, not to the ECU) * I've tried both the S and the Man commands in both 9600 and 19200 baud and don't get anything, just the little <0> sometimes, so not surprisingly: ** when I try uploading firmware, all I get is "No hello from AVR" Advices? Measure a few more things: * supply voltage and supply current draw of the board * onboard supply voltages, including the 4..5 supply (+5V) of the processor Try ECU '''serial loopback''' * power down * connect ECU rs232 DSUB9pin2 to DSUB9pin3 * powerup * TerminalProgram 19200,8n1 say "S" => expect AVREFI1 * now you can upload program with the upload_firmware.bat '''IF YOU REMOVE THE 't' from the megaloader vems.hex .... Etw''' command (so Etw becomes Ew, or if it's like "-w -t", than drop the "-t" ) since you are already in bootloader. You'll need the "t" later when you want to reflash normally (firmware running, not in bootloader mode) ** or you can try the experimental v3gui (download from MegaTune page). ---- This is where my car sits right now, I'm down to some of the last few details for getting it running and one of those hangups is my VEMS V3.2. I've had the controller for a while but have just recently been needing to use it. http://myweb.cableone.net/mjbless/project/2.jpg http://myweb.cableone.net/mjbless/project/4.jpg http://myweb.cableone.net/mjbless/project/5.jpg My coil pack setup, my only fear with this setup is finding a way to get rotary trailing split to work. http://myweb.cableone.net/mjbless/project/11.jpg
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.