###  
   ##    
  #####  
   ##    
   ##    
   ##    
         

 _     _ 
( )   ( )
`\`\_/'/'
  `\ /'  
   | |   
   (_)   
         
         

    ##   
   #  #  
   #     
 #####   
   #     
   #     
   #     
         

   ##    
    #    
    #    
    #    
    #    
    #    
   ###   
         

         
         
 #####   
 ##  ##  
 ##  ##  
 #####   
 ##      
 ##      

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
I'm using a two wire Bosch knock sensor on my engine with 86,5mm bore. ---- '''Wiring''' .... ---- '''Testing''' * Cling the block with wrench and record with soundcard. * optional: ** Check FFT for freq. ** Upload the wav. ---- I setup the knock parameters in Megatune as discribed in MembersPage/PhatBob/UserGuide, ---- '''Problem''' But my knock diff gauge displays 1000000. What can this be? It stays the same if sensor is connected or disconnected from cable harness. if you capture mll (in terminalprogram, while on knock page), can you paste more ?
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.