######  
  ##  ## 
  ##     
  ##     
 ####    
         

         
         
  ####   
     ##  
  #####  
 ##  ##  
  #####  
         

 _____ 
(_   _)
  | |  
  | |  
  | |  
  (_)  
       
       

         
         
  ####   
     ##  
  #####  
 ##  ##  
  #####  
         

         
  ###    
   ##    
   ##    
   ##    
   ##    
  ####   
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
Related to BMW M52 MembersPage/BmwMFiftyTwo ---- '''Measure HALL trigger supply voltage''' Related to: * mot88/54 * mot88/65 ---- * Serialnr * Vemslog captured with VemsTune during the cranking attempt could reveal something (eg. it would be awesome if only some configuration adjustment would be needed). However, '''for trigger problems more measurements are almost always needed also''': * Measuring triggers, DC and AC voltage ** OscilloScope the trigger signal might be necessary * InputTrigger/TriggerLog ** this might reveal that signal is missing from only primary or only secondary HALL sensor (or both). ---- Preferrably create custom page for the project (but editing this page to provide information is temporarily OK, possible to organize later, just define some project nickname ). ---- '''Old harness''' We have a 6cyl BMW harness with 4 connectors of female 3-pin injector (AMP) '''TPS''' * mot88/42 (TPS GND or shield ???) * '''mot88/12 TPS signal''' (EC36/1) * '''mot88/44 +5V''' for TPS '''primtrig HALL: Crank sensor''' * mot88/48 Crank sensor +5V * mot88/83 Crank sensor signal (EC36/27) * mot88/40 Crank sensor GND (EC36/26) '''sectrig HALL: CAM sensor''' * '''mot88/65 CAM sensor 12V''' ( diode to ->|- mot88/54 might be undesirable ??) * '''mot88/64 CAM sensor signal HALL EC36/13 * '''mot88/43 GND''' '''Idle''' * mot88/27 Idle (INJ-H with low voltage flyback) * mot88/54 '''Cam sensor 12V (on the idle connector ???)''' * mot88/53 Idle (INJ-G with low voltage flyback) Maybe this is from some other harness, not M52 ? * maybe M60 (didn't check just blind guessing) ---- '''M52 Test bench''' Planned: '''M52 harness from E39 manual transmission''' Acquiring a harness from E39 for more tests.
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.