_     
( )    
| |    
| |  _ 
| |_( )
(____/'
       
       

 _______ 
(  ___  )
| (   ) |
| |   | |
| |   | |
| |   | |
| (___) |
(_______)
         

         
         
 ##  ##  
 ##  ##  
 ##  ##  
  #####  
    ##   
 ####    

         
   ##    
         
  ###    
   ##    
   ##    
  ####   
         

 __      __
 \ \    / /
  \ \  / / 
   \ \/ /  
    \  /   
     \/    
           
           

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
Subpage of MembersPage/BmwMFiftyTwo * '''STRONGLY recommended: BY399 throughole (or STPS340U SMB) diode between injector shared +12V BMW88/87 (anode) and BMW88/26 VBATT (Cathode)''' ** even an 1n4007 is better than nothing (this diode is shorted by the DME relay anyway, but during relay switching, it does not hurt). Alternatively, it might '''make sense to connect EC36/23 flyback rail to BMW88/26 (VBATT=node30) rather than BMW88/87''' ** if there is a 18V transient diode to GND, or a diode from BMW88/87 to BMW88/26 (inside ECU or in harness) it makes little difference, otherwise it might be safer ---- '''BMW88/69 Fuel pump relay solenoid pulled down to 0.2V by EC36/15 p259/ch5 output''' * this should safely activate the relay * you can try to disable fuel pump, and configure misc2 output as test (or even try all other p259 channels, just in case). * Can you measure at the ECU output pin (from 12V as a base ?)
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.