##   
         
    ##   
    ##   
    ##   
    ##   
 ####    

  _      
 | |     
 | |     
 | |     
 | |____ 
 |______|
         
         

 _____ 
|  __ \
| |  \/
| | __ 
| |_\ \
 \____/
       
       

         
         
 #####   
 ##  ##  
 ##  ##  
 ##  ##  
 ##  ##  
         

 _   _ 
( ) ( )
| | | |
| | | |
| (_) |
(_____)
       
       

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
Suzuki Swift 4 cyl ? * Runs. * runs well when cold * runs well when warm, upto 5500 RPM ** primary trigger problem when warm, above 5500 RPM ** ECU was tested to sense good signal to almost 4x higher... So most likely the HALL sensor does not pull sufficiently to GND when warm, or does not sense the pulses reliably ('''home-made wheel is a primary suspect'''). The engine crankshaft wheel was modified, and the ECU was also modified (apparently originally ordered with VR, HALL, but changed to HALL, HALL ?). Maybe the pullup resistor was installed on the wrong side ? (not the input, but the internal side of the protection resistor ?) * no sign of that. Should be good '''ECU primary trigger HALL input passed test of 720000 pulses / minute''' (12000 RPM with 60-2 config, equivalent 20000 RPM with 36-1 config) without any sign of problem. Bad sensor test was not done. Eg. 1 diode can simulate a sensor that cannot pull down to below 0.4V (as a good HALL sensor), but only to appr 1V. That would be interesting... ---- '''Do you have oscilloscope ?''' cranksensor: factory 36-2-2-2 HALL was replaced with '''36-1 HALL.''' * sensor type ? * axial or radial sensor placement ? ** '''radial''' * min and max distance (as wheel rotates) * '''wheel geometrics''' ? ** diameter ? ** thickness ? ** '''Photo of the wheel''' ? ** window size ? ** material ? not stainless, right ? v3 ECU has HALL, HALL input * primtrig HALL = 620mV when measured with 1k pulldown (so internal pullup is appr 7k equivalent, although this is a bit unusual ... 2k7 .. 4k7 is usual). ---- When engine is warm, trigger error (and misfire) above 5500 RPM. It is suspected that primtrig HALL sensor does not pull to GND (or to <0.5V) as it should but perhaps to 1V or so ? ** they claim the sensor was replaced (with another factory HALL sensor of same type) and problem persists, so it is reproducible
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.