#####  
 ##  ##  
 ##  ##  
  #####  
     ##  
     ##  

 ___   
(  _`\ 
| ( (_)
| |___ 
| (_, )
(____/'
       
       

         
         
 ##  ##  
 ##  ##  
 ##  ##  
  #####  
     ##  
 #####   

         
         
  #####  
 ##      
  ####   
     ##  
 #####   
         

         
         
  #####  
 ##  ##  
 ##  ##  
  #####  
     ##  
 #####   

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
1993 Audi USA B4 90 quattro with 4.2 ABZ V8. ECU V3.6 FW 1.2.20 VT 1.5.46 60-2 TTV flywheel Audi OEM cam sensor OEM injectors (220cc) quite small, should be easy to tune OEM sensors *** SUCCESS! Obtained good config from member Dangerrous, spent some hours verifying pinouts and calibration, then VROOM! Discovered that main problem was TDC after trigger was 30 degrees too high, as suggested by anonymous member. I suspected this but was too dumb to make the math with the engine installed - no access to sensor, but invented a way last night. Still need timing light to fine tune. Right now there is strange behavior from the ISV in that it won't go below 1300 rpm and attempts to lower the rpm result in HIGHER rpm. So... carefully reading the documentation (rtfm). Ah yes... INVERT the output! Sometimes I wonder how I can even tie my shoes. ---- Fill in these pages with all the required info and watch your config be pretty much built for you MembersPage/BenNesbitt/IgnitionPage MembersPage/BenNesbitt/WBsensor MembersPage/BenNesbitt/FuelPage MembersPage/BenNesbitt/InputTrigger MembersPage/BenNesbitt/IdleControl MembersPage/BenNesbitt/SensorPage MembersPage/BenNesbitt/ConfigPage
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.