______ 
|  ___|
| |_   
|  _|  
| |    
\_|    
       
       

         
         
 #####   
 ##  ##  
 ##  ##  
 ##  ##  
 ##  ##  
         

    ###  
     ##  
     ##  
  #####  
 ##  ##  
 ##  ##  
  ###### 
         

 _   __
| | / /
| |/ / 
|    \ 
| |\  \
\_| \_/
       
       

         
  ###    
   ##    
   ##    
   ##    
   ##    
  ####   
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
new to the site. '''ECU SPECS''' Board_version=v3.3 Serial_nr= 2692 pump-= 4.0V wbo2_pump_pw_zero=0x64 wbo2_nernstdc_target=0x86 pump+= -2.7mV/200 Ohm AREF=4.9V (C103=1nF, no D100) ------------------------------------------------------ '''Engine Specs:''' -VW 2.0 16v ported headed. Built Bottom End -GT35R -EP racing manfiolds -VEMS 3.3 -400kpa built in Map engine build is done Harness is in the car wiating on some more bosch crimp end connectors to finish the last few sensors to wire ECU POWERS ON TODO: this week - finish wiring, testing, config sensors ------------------------------------------------------ '''Harness Specs:''' -12v IGN: 12AWG to EC36 pin 25 -GND: 12 AWG to EC-36 pins 5,21,22,32,26 sensor GND wire -Ignition: EC36 pin 34, 36 (coils 2 & 3) -TPS: EC36 pins 1,29, grnd -IAT EC36 pin 2 -Injectors EC36 pin 7,19,8, 20 -VR: EC36 pin 27 -Ch5 Output Pin 15 - fuel pump relay -Ch1 Output Pin 31 - Fan Relay -Ch4 Output Pin 3 - Shift Light -Ch0 Output Pin 4 – Tach out -Analog 7 EC18 pin 12 with input from EC36 pin 29 launch control
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.