___   
(  _`\ 
| ( (_)
| |___ 
| (_, )
(____/'
       
       

  _____ 
 |  ___|
 | |_   
 |  _|  
 |_|    
        

 _______ 
(  ____ \
| (    \/
| (_____ 
(_____  )
      ) |
/\____) |
\_______)
         

    ##   
   #  #  
   #     
 #####   
   #     
   #     
   #     
         

  ______
 |___  /
    / / 
   / /  
  / /__ 
 /_____|
        
        

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
memberspage/bdcoombs/test '''ECU SPECS''' Board_version=v3.3 Serial_nr= 2692 pump-= 4.0V wbo2_pump_pw_zero=0x64 wbo2_nernstdc_target=0x86 pump+= -2.7mV/200 Ohm AREF=4.9V (C103=1nF, no D100) ---- '''Engine Specs:''' *VW 2.0 16v ported headed. Built Bottom End *GT35R *EP racing manfiolds *VEMS 3.3 *400kpa built in Map engine build is done Harness is in the car ECU POWERS ON ------------------------------------------------------ '''Harness Specs:''' *12v IGN: 12AWG to EC36 pin 25 *GND: 12 AWG to EC-36 pins 5,21,22,32,26 sensor GND wire *Ignition: EC36 pin 34, 36 (coils 2 & 3) *TPS: EC36 pins 1,29, grnd *IAT EC36 pin 2 *Injectors EC36 pin 7,19,8, 20 *VR: EC36 pin 27 *Ch5 Output Pin 15 - fuel pump relay *Ch1 Output Pin 31 - Fan Relay *Ch4 Output Pin 3 - Shift Light *Ch0 Output Pin 4 – Tach out *Analog 7 EC18 pin 12 with input from EC36 pin 29 launch control
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.