##### ## ## ## ## ##
### ## ### ## # ##### ## ## ## ## #### ###
#### ## ## ###### ## #####
## ### ## ## ## ## ## ## ####
### ## ##### ## ## ##
IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now. Visit Preferences to set your user name Summary of change: The car has a 6 cylinder engine with the following sensors and actuators: *VR crank sensor with a 60-2 trigger wheel *Hall sensor on camshaft for sync *Bosch coolant temp sensor *Mass air flow sensor (to be eliminated) with air inlet temp sensor *Throttle position sensor *2-wire idle stability valve *dumb waste-spark coilpack *rpm signal from ECU to instrument cluster tachometer A list of the ECU and VEMS pinouts is in table below: || ||VW ECU pin||VEMS pin|| ||Crank sensor signal||68||EC36-27|| ||Crank sensor ground||67||EC36-26|| ||Camshaft sync signal||44||EC36-13|| ||Coolant sensor||14||EC36-14|| ||Air temp sensor||36||EC36-2|| ||TPS reference voltage||40||EC36-1|| ||TPS signal||41||EC36-28|| ||Idle control valve||53||EC36-?|| ||Switched 12V supply||38(jumper to 27 for ISV and 23)||EC36-25|| ||Coil A||8||EC36-35|| ||Coil B||60||EC36-33|| ||Coil C||52||EC36-34|| ||Sensor grounds||33,42||EC36-26|| ||Main grounds||1,7,55,56,58||EC36-5,21,32|| ||Knock sensor 1||34||EC36-3|| ||Knock sensor 2||37||EC36-3|| ||Injector 1||24||EC36-7|| ||Injector 2||3||EC36-19|| ||Injector 3||26||EC36-8|| ||Injector 4||4||EC36-20|| ||Injector 5||25||EC36-9|| ||Injector 6||2||EC36-18|| ||Injector common||??||EC36-23|| ||ECU power relay||9||jumper to switched power|| ||Fuel pump relay||6||EC36-9|| ||Charcoal canister||9||EC36-? (boost)|| other people doing vr6 installs: MembersPage/CameronBrewster ...to be cleaned up later Optional: Add document to category: Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.