###    
   ##    
   ##    
   ##    
   ##    
   ##    
  ####   
         

         
### ##   
 ### ##  
 ##  ##  
 ##  ##  
 ##  ##  
#### ### 
         

    ##   
   #  #  
   #     
 #####   
   #     
   #     
   #     
         

         
         
 #####   
 ##  ##  
 ##  ##  
 ##  ##  
 ##  ##  
         

   _____ 
  / ____|
 | (___  
  \___ \ 
  ____) |
 |_____/ 
         
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
Trigger related subpage of MembersPage/BasilDaham/CordobaSX Apparently spent weeks (or months), and generated [http://vems.hu/www.vems.co.uk/forum/index.php?topic=535.0 1000 lines] of text, yet, '''there is still no good overview''' on the trigger setup, wiring and measurements (~50-100 lines). See sg. like MembersPage/BorisRieken The v3 #671 was replaced after damage, #1746, (theoretically HALL, HALL trigger) ---- '''Primary trigger HALL 60-2''' At TDC tooth 15. (tooth0 is the tooth selected edge after missing tooth, tooth10 is 6 crankdeg later, etc...) '''verify the internal pullup resistor''' * temporarily connect a 1k resistor between EC36/27 and GND ** measure voltage. (above 1V for strong pullup - preferred for HALL; below 500mV for weak pullup - preferred for VR). Than measure how the '''EC36/27 voltage''' changes when you rotate engine (push car in gear5). It should go * down to 0.1V or so * and up to 3V or above for each tooth. Than you need to publish details about your setup IssueReports for checklist * firmware * '''mcd / mct dump''' * logs * etc... It might be something simple, but publish these first. ---- '''Secondary trigger HALL''' Hall-effect sensor on camshaft for camsync (1-window trigger wheel) * '''Position ???? ''' * Chosen edge ?
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.