_____ 
|_   _|
  | |  
  | |  
  | |  
  \_/  
       
       

    ###  
   ##    
   ##    
 ######  
   ##    
   ##    
   ##    
         

         
         
  ####   
     ##  
  #####  
 ##  ##  
  #####  
         

 __     __
 \ \   / /
  \ \ / / 
   \ V /  
    \_/   
          

         
         
 ##  ##  
 ##  ##  
 ##  ##  
 ##  ##  
  ###### 
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
Audi URS4 AAN engine with both supercharger and turbo. 5 cyl COP 850cc injectors Power target 700hp 2.2l original wastegate, idle control etc Progress to date: New installation of VEMS 3.6 on 1.1.95 * separate 55pin to EC18/36 connector soldered a cording to an AAN_Build_Doc and pinout received with the unit. * Still have to solder the PC interface connector - not sure about the pinout. ** See "RS232" on [http://shop.vems.hu/catalog/assembled-controller-p-48.html the webshop product page] I'm also not clear as to how to load the config files / set them up for the injector size, nor any other small setup/configs to do. * Also see the [http://shop.vems.hu/catalog/vems-motronic55-p-122.html motronic55 related webshop product page]. ** eg it refers to VemsTune/QuickStartAudi page I have worked with 55pin VEMS before on this car (borrowed from a mate) and it ran well. So tuning etc relatively comfortable with - but the unit came setup already for AAN, this time I had to use GEN 3.6. * The internals are the same, but make sure to follow the instructions, eg. connect the 5 grounds together, read the warnings on the paper. * The Flyback motronic55/37 to ec36/23 is also very important
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.