##      
 ##      
 ## ##   
 ####    
 ## ##   
 ##  ##  
         

  ______ 
 |  ____|
 | |__   
 |  __|  
 | |     
 |_|     
         
         

 _   __
| | / /
| |/ / 
|    \ 
| |\  \
\_| \_/
       
       

         
         
  #####  
 ##  ##  
 ##  ##  
  #####  
     ##  
     ##  

   ##    
         
  ###    
   ##    
   ##    
   ##    
 ######  
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
Similar to * MembersPage/RicoZiemer I want to buy VEMS and put it to my BWM E28 528i '84 with a M30B28 engine running L-Jetronic engine managment. I want to keep an original sensors, wires etc. I have intention to order Assembled v3.3 controller in this setup: <PRE> 1-wire interface: NO Flyback: 30V ignition driver: 0 Knock and EGT: YES (with second knock sensor input wire to EC18pin2) LCD connection: YES MAP connection: 400kPa (6/4mm pneumatic) mounting-style: NO-SCREWS primary_trigger: VR PS2 connection: NO secondary_trigger: AUDITRIGGER </PRE> I hope, that the configuration what I chose will allow me to trouble-free connect and start VEMS. ---- '''Trigger''' To verify VR, Please measure inputtrigger resistance of both sensors. Should be same (usually 400..1300 Ohm) in both directions. * measured primary trigger resistance = ... '''FILL THIS IN''' * measured secondary trigger resistance = ... '''FILL THIS IN''' ---- I need some help on my project, thank you.
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.