_  __
 | |/ /
 | ' / 
 |  <  
 | . \ 
 |_|\_\
       
       

 #       
 #       
 # ###   
 ##   #  
 #    #  
 ##   #  
 # ###   
         

         
         
 #####   
 ##  ##  
 ##  ##  
 #####   
 ##      
 ##      

 _______ 
(  ___  )
| (   ) |
| (___) |
|  ___  |
| (   ) |
| )   ( |
|/     \|
         

         
         
 ##   ## 
 ## # ## 
 ####### 
  #####  
  ## ##  
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
'''BMW M44B19 engine 1997''' Motronic 88 pin harness in BMW E36 318is * VR / HALL * 4 IGBT seems enough * stepper chip might not be needed '''Primary trigger''' VR, but polarity is not confirmed. Best guess (without measurement, so not confirmed) * '''mot88/78=EC36/27''' (black ?) ** Pin 78 is the positive signal - Gunni ** (hopefully 3 * tooth time between falling edges at the missing tooth of the 60-2 wheel... and rising slowly in the middle) * '''mot88/20=GND''' (yellow ?) ** '''ANY INFORMATION IS WELCOME. IF YOU HAVE ACCESS TO BMW M44 harness, please check colors (is the above correct ?)''' ** If you have engine, or installed before, any scopeshot or notes would be welcome. Thanks. ---- The '''Mechanical keying of the M44 harness mot88 connector''' would be nice to see also (although easy to cut out if necessary). Any info or pic welcome. Thanx. ---- '''IDLE actuator / ISC valve''' * M44/pin2 and M44/pin29 (open/close) direction matches M52 ? ** apparently '''M44/pin2 should be inj-H''' (like M52/pin27 if the BMW ISC valve drawings on '''p104 and p132''' are consistent; ) ** '''inj-G and inj-H with low Voltage flyback''' (like with M52) * resistance (ohm) ? ---- '''Valves''' * '''M44/pin58 Changeover valve''' resistance ? * '''M44/pin61 EVAP valve''' resistance ? ---- '''Relays (usually 92 .. 120 Ohm ?)''' * '''M44/pin27 DME relay''' (resistance ?) ** flyback diode removed or changed to 18V bidir for p259/1 (EC36/1) controlling DME relay * '''M44/pin63 Fuel pump relay''' (resistance ?) * '''M44/pin57 Aux fan relay''' (resistance ?) ---- '''AC ON input''' * M44/pin69 need pullup or does not matter ? ** There looks to be an internal pull down in the OEM ECU so no a pullup is not needed. ---- See [http://vems.hu/download/v3/Motronic88/ M50-vanos-vs-s50b32-vs-M60B40_B30.xls] M44 column (and other 2020-07-xx files)
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.