_       
| \    /\
|  \  / /
|  (_/ / 
|   _ (  
|  ( \ \ 
|  /  \ \
|_/    \/
         

 __          __
 \ \        / /
  \ \  /\  / / 
   \ \/  \/ /  
    \  /\  /   
     \/  \/    
               
               

     ##  
     ##  
  #####  
 ##  ##  
 ##  ##  
 ##  ##  
  #####  
         

         
##  # ## 
##  #  # 
 ## ## # 
 ### ##  
  ## ##  
  #   #  
         

  ###    
   ##    
   ##    
   ##    
   ##    
   ##    
  ####   
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
I am modifying an 88 Honda Legend. There are 2 stages to this At the moment i have a c20at motor which is a 2 litre turbo V6 that i am in the process of transplanting that i will drive while i build my secont motor. It is wired up with the wiring loom from a c27a (the original motor from the car). I am going to build a 2.7 litre turbo motor from a N/A c27a that will hopefully go in the car in about 18 months time. I would like to design a vems computer to run this but have a lot of questions. Just for a start off will i be able to wun it through my wiring loom with a couple of sensors added or will i need to get a new loom?
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.