_   _ 
 | | | |
 | | | |
 | |_| |
  \___/ 
        

 _______ 
(  ____ )
| (    )|
| (____)|
|     __)
| (\ (   
| ) \ \__
|/   \__/
         

         
         
  #####  
 ##  ##  
 ##  ##  
  #####  
     ##  
 #####   

       _ 
      | |
      | |
  _   | |
 | |__| |
  \____/ 
         
         

  __  __ 
 |  \/  |
 | |\/| |
 | |  | |
 |_|  |_|
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
'''1991 Audi 100''' (5cyl 2 valve engine) originally with KE Jetronic (weird, many older engines had proper fuel injections; this might be the last KE-Jetronic engine built) * fuel rail fabricated * will be kept NA (normally aspirated). 139 Hp ? Smooth and clean running and fuel economy is main target (not power) ** factory compression ? Around 9.6 ? * KE jetronic => replaced with VEMS (speed density setup, 115 kPa MAP sensor) ** owner planned to "alien-log" the factory ignition advance table. However, there is almost certainly no value in that table. Should not be big deal to make a better igntune (for RON95 fuel). Probably the orig is tuned for pessimistic lower RON fuel * ditributer kept for now * either 35pin factory connector kept, and VEMS made with frontplate for that connector '''NOT feasible, because one connector is for ign, other for fuel, better cut off...' ** => '''wires cut and EC36 + EC18 connector crimped''' the way to go If tuned in August, might need some tune adjustment in the winter. ---- '''Sensors''' * MAT ? * WBO2 will be added * knock ? Does the block have provision for 2 bolts ? ---- '''A/C''' compressor is in, but was not operated for some time. Needs gas, most likely (or was it washed and changed to R134A ? dunno) ---- '''Trigger''' * primtrig: 5 window HALL (on camshaft, in distributer) * sectrig: HALL (not used for now) ---- '''Notes''' Factory harness schematics: https://www.vems.hu/~vemshu/files/MembersPage/MarcellGal/Audi/KEjetronicOut/ eg.: https://www.vems.hu/~vemshu/files/MembersPage/MarcellGal/Audi/KEjetronicOut/nf01.jpg ---- '''injector''' Bosch 280 150 716 (donation from some BMW) cc/min ? recommended cranking pw at 20C ? Or req_fuel for VE=100 or VE=200 ?
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.