__   __
 \ \ / /
  \ V / 
   > <  
  / . \ 
 /_/ \_\
        
        

         
         
 #####   
 ##  ##  
 ##  ##  
 ##  ##  
 ##  ##  
         

         
         
  ####   
 ##  ##  
 ##  ##  
 ##  ##  
  ####   
         

         
|\     /|
| )   ( |
| (___) |
|  ___  |
| (   ) |
| )   ( |
|/     \|
         

  ____  
 |  _ \ 
 | |_) |
 |  _ < 
 | |_) |
 |____/ 
        
        

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
= Sensor Page = MembersPage/AntonLilja ---- == Inlet Air Temperature == Stock Audi temp sensor for turbo motors: http://www.vems.hu/files/AntonLilja/P03-28-06_16.272.jpg '''Q''': This has a PTC thermistor that reads around 500ohm at 20C, part number is 035 905 379 C (now replaced by 034 905 379 B, same except for a different connector). This is compatible with VEMS, see "PTC" on EasyTherm. Since the slope is very high, careful calibration is recommended. Miska Peippo used the PTC curve, AFAIK. == Throttle Position == From a 3B engine. Part number 034 133 154 F. http://www.vems.hu/files/AntonLilja/tpsKit.jpg Pinout: || 1 || VCC || || 2 || Output || || 3 || Ground || || 4 || Unused || || 5 || Idle Switch || || 6 || Idle Switch || '''Q''':Can anyone confirm that VCC +5v is ok? I read 3.3v somwhere. == Coolant Temperature == Stock. Will look into this later. == Manifold Absolute Pressure == MPX4250AP 250kPa from WebShop. Soldered on board (initially upside down, this should be clearer in documentation). Will probably have to upgrade to 400kPa later on but I will use this for initial testing. == !WideBand Lambda == Bosch LSU4 sensor from WebShop. Sumitumo connector to Genboard. == Variable Reluctance == Will most likely use stock Audi sensor in conjunction with the 60-2 wheel. See MembersPage/AntonLilja/Trigger == Hall == Either fork sensor from a distributor or homemade with magnet and hall element from WebShop in conjuction with window-wheel on cam. See MembersPage/AntonLilja/Trigger
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.