___   
(  _`\ 
| (_(_)
|  _)  
| |    
(_)    
       
       

  ____  
 |  _ \ 
 | |_) |
 |  __/ 
 |_|    
        

 _   _ 
( ) ( )
| | | |
| | | |
| \_/ |
`\___/'
       
       

  ____  
 | __ ) 
 |  _ \ 
 | |_) |
 |____/ 
        

         
         
  #####  
 ##      
  ####   
     ##  
 #####   
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
= Notes = MembersPage/AntonLilja ---- '''Outputs''' The FET and IGBT places on the board can be assigned with much freedom. See GenBoard/Manual/DigitalOut, GenBoard/Manual/DigitalOut/Table * injectors => injector outputs * ignition => ignition outputs (logiclevel for active coils; IGBT based power outputs for passive coils) * bipolar stepper (if used) => stepper outputs * other outputs => after assigning the above use the remaining outputs. take care about current rating and flyback protection (eg. WBO2 second channel FET and DPAK "extraFET"-s have no flyback installed by default!) ** Use the higher current stuff first for more safety ** except for (low current like) LEDs (like shiftlight), where p259 outputs are the best ** don't forget flyback and GND and GND5 connections
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.