______ 
| ___ \
| |_/ /
| ___ \
| |_/ /
\____/ 
       
       

     _    
    / \   
   / _ \  
  / ___ \ 
 /_/   \_\
          

         
         
  ####   
 ##  ##  
 ##      
 ##  ##  
  ####   
         

  __  __ 
 |  \/  |
 | |\/| |
 | |  | |
 |_|  |_|
         

         
   ##    
         
  ###    
   ##    
   ##    
  ####   
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
= Notes = '''Outputs''' The FET and IGBT places on the board can be assigned with much freedom. See GenBoard/Manual/DigitalOut, GenBoard/Manual/DigitalOut/Table * injectors => injector outputs * ignition => ignition outputs (logiclevel for active coils; IGBT based power outputs for passive coils) * bipolar stepper (if used) => stepper outputs * other outputs => after assigning the above use the remaining outputs. take care about current rating and flyback protection (eg. WBO2 second channel FET and DPAK "extraFET"-s have no flyback installed by default!) ** Use the higher current stuff first for more safety ** except for (low current like) LEDs (like shiftlight), where p259 outputs are the best ** don't forget flyback and GND and GND5 connections
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.