_    _ 
| |  | |
| |  | |
| |/\| |
\  /\  /
 \/  \/ 
        
        

   ___ 
  |_  |
    | |
    | |
/\__/ /
\____/ 
       
       

         
         
  ####   
 ##  ##  
 ######  
 ##      
  ####   
         

         
         
  #####  
 ##  ##  
 ##  ##  
  #####  
     ##  
     ##  

         
         
  #####  
 ##  ##  
 ##  ##  
  #####  
     ##  
 #####   

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
= Assembly = MembersPage/AntonLilja ---- == Progress == What's been done so far: * Soldered inductor and fuse link and crystal which was missing for knock * Soldered pin headers for serial, keyboard and LCD * Soldered both Econoseal connectors * Soldered wires for supply and connecting GND and GND5 at the board, only for testing * Made DSUB connectors for serial keyboard and LCD * Knock and EGT chips are on board * Initial testing; connecting and communicating with PC, keyboard/LCD communication, updating firmware through bootloader Apart from a firmware incompatibility issue all is good so far. 28/03/06 Update: * Drilled frontplate for pneumatic connector * Updated firmware to 1.0.34 * Mounted MAP sensor, vacuum connection and frontplate to GenBoard * Did AREF=256 mod, soldering a 33ohm resistor to a trace * Setup trigger hardware: ** Solder jumper JP2 & JP7 ** Solder blob SJ6 ** R181 = 100k ** Replaced C103 with 1nF ---- == Notes ==
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.