### ### 
  ### ## 
  ##     
  ##     
  ##     
 ####    
         

   ___  
  / _ \ 
 | | | |
 | |_| |
  \___/ 
        

         
         
  ####   
 ##  ##  
 ##  ##  
 ##  ##  
  ####   
         

         
   ##    
 ######  
   ##    
   ##    
   ##    
    ###  
         

 __     __
 \ \   / /
  \ \_/ / 
   \   /  
    | |   
    |_|   
          
          

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
= Assembly = MembersPage/AntonLilja ---- == Progress == What's been done so far: * Soldered inductor and fuse link and crystal which was missing for knock * Soldered pin headers for serial, keyboard and LCD * Soldered both Econoseal connectors * Soldered wires for supply and connecting GND and GND5 at the board, only for testing * Made DSUB connectors for serial keyboard and LCD * Knock and EGT chips are on board * Initial testing; connecting and communicating with PC, keyboard/LCD communication, updating firmware through bootloader Apart from a firmware incompatibility issue all is good so far. ---- == Notes == '''serial number 303''', sent out on 2005-07-09 (among the first 5 v3.3 - these had no R181 PNP-ed) * apparently you assembled yourself: '''confirm R181 has been soldered''' (100 .. 180k) according to the note you received from the shop: If using VR on primary trigger, please check R181 100k (0805 size SMD)resistor at LM1815 pin7. (min 47k, max 180k; 100k recommended: you can find 100k in rescue kit marked as 104 ). ** R181 is connected to '''LM1815pin7''', so NOT the two pads right next to LM1815 pins 6 & 7 (which is the 3 pin header connected to LM1815 pin5, leave that 3 pins open!) ** You do not actually need the R181 resistor when using HALL as primary, but recommended to install it anyway to avoid future surprise (if using VR later). Anyway, have a note about this in the logs (or trigger related notes) that you write for your ECM. ** believe it or not, I independently copied the old R181 note (we even had an edit conflict when I saw your question and added more info on the pin). * remove D100 if you use powerflyback GenBoard/Manual/PowerFlyback/RemoveD * change C103 to 1nF if using secondary trigger HALL : Manual/InputTriggerHardWare/ReplaceC * set AREF=256 BuildProcedures/SectionThree (not required but recommended) '''Q''': Are you supposed to replace a resistor on the board or change a value in the config for AREF=256? It's not really clear.
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.