### #  
 #   ##  
 #   ##  
  ### #  
      #  
  ####   

   ####  
  ## #   
  ##     
 #####   
  ##     
  ##     
 ####    
         

         
         
 ##  ##  
 ####### 
 ####### 
 ## # ## 
 ##   ## 
         

         
         
 #####   
 ##  ##  
 ##  ##  
 #####   
 ##      
 ##      

 __        __
 \ \      / /
  \ \ /\ / / 
   \ V  V /  
    \_/\_/   
             

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
After '96 1JZ-GTE, 2JZ-GTE engines equipped with VVTi for intake camshaft. So i have 1JZ-GTE, it is single turbo 2.5L CR=9.0, stock rated as 280hp at 165kPa. Primary trigger VR 36-2 at crank, secondary VR 3teeth even wheel at intake cam. Engine hardware allows to control camshaft angle in interval 60crankdeg. "VVTi PID controller" and "Target camshaft position table" was added to firmware, some extra code for calc camshaft position was written too. Both target pos and actual pos are present in MT log Stock camshaft position table was captured with old known alien advance feature. Also at cold engine we need retard camshaft for reduce VE at warmup and save fuel. OE ECU retard camshaft at low rpm for reduce VE and knock, see my table. Digits in table: bigger - advance, less - retard. PID works even faster than stock without reference table. http://www.vems.hu/files/MembersPage/Andrey/VVTi_Target.JPG http://www.vems.hu/files/MembersPage/Andrey/VVTi_Settings.JPG
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.