## ## ##### ## ## ## ## ## ##
### ## ## ## ## ####
##### ## ## ## ## ##### ## #####
____ / ___| \___ \ ___) | |____/
______ |___ / / / / / / /__ /_____|
IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now. Visit Preferences to set your user name Summary of change: Audi 200 turbo quattro avant 10vt. The ECU suffered damage: the EC36/28 output was broken. Likely due to HALL sensor connection problem. ECU output fixed (regulator swapped). Other ECU functions seem unaffected. Before install can continue, fill in ALL outputs (injection and ignition as well!) ---- 36/1: tps in 36/2: iat in 36/3: tacho out 36/4: fuel relay 36/14: clt in 36/27: primary trigger 36/28: +5V supply (what does "not working" mean ? Is it shorted to ground ?) '''Check with DVM diode mode that it's not shorted to ground or +12V''' 36/29: tps supply (not working) ground: 36/5,21,22,26,32 iac 5.54kohm at 4C clt 5.45kohm at 4C ground checked to battery. all 0.3 ohm 36/19 iac (checked to another injector outs.. 11.2 ohm) 36/24 iac ---- '''Injector outputs''' Fill them in. All 5 injectors * ... cyl3 * 36/9 inj cyl 5 * ... cyl4 * ... cyl2 * ... cyl1 '''TODO: Measure this: EC36/23 flyback must be connected to injector common''' (even with ignition off) ---- '''Ignition outputs''' Fill them in '''36/35 coil''' logic level or power IGBT output needed ? distributer ? If not, fill in: * ... cyl3 * ... cyl5 * ... cyl4 * ... cyl2 * ... cyl1 Optional: Add document to category: Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.