#    
 ######  
   ##    
   ##    
   ##    
   ## #  
    ##   
         

         
         
 #####   
 ##  ##  
 ##  ##  
 ##  ##  
 ##  ##  
         

         
     ##  
     ##  
  #####  
 ##  ##  
 ##  ##  
  #####  
         

  _  __
 | |/ /
 | ' / 
 |  <  
 | . \ 
 |_|\_\
       
       

    ##   
   #  #  
   #     
 #####   
   #     
   #     
   #     
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
Already replaced stock Bosch Motronic M2.10.3 with VEMS 3.6. Stock wiring is used for installation, so I had to use Motronic 55 pin connector and VEMS GenBoard. Also some very small adjustments to stock wiring were applied for MAP sensor instead of MAF. Items used: 1. Vems GenBoard v3.6 2. Alubos case with motronic55 frontplate 3. 8 x Ignition driver 4. 10 x Injector or WBO2 heater driver 5. Idle stepper motor driver 6. Wideband connector 7. Dual channel knock sensor interface 8. EGT amplifier chip Additionally were bought: 1. Wideband sensor 2. Cheapest external MAP sensor I've found from Reanult Logan.
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.