### #### 
 ##  ##  
 ##  ##  
 ##  ##  
 ######  
     ##  
 #####   

   _____ 
  / ____|
 | (___  
  \___ \ 
  ____) |
 |_____/ 
         
         

         
  ####   
 ##  ##  
 ######  
 ##      
 ##      
  ####   
         

 _______ 
(  ___  )
| (   ) |
| |   | |
| |   | |
| |   | |
| (___) |
(_______)
         

   ##    
         
  ###    
   ##    
   ##    
   ##    
 ######  
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
'''Wideband Calibration''' Current Issue on 1/5/2006 I wanted to verify my wideband calibration again just to be sure. I followed the instructions for wbo2 calibration in the Userguide. board sent out status: Board version =v3.3 serial=374 pump-=4.00V (I don't know what these values mean?Can I check them?) pump_pw_zero=0x64(this one is OK) pump+=3.93V Measurements: *wbo2_pump_pw_zero=0x64 reads 0,02V across pin 5-6 *with wbo2 disconnected I've put 2 100 Ohm resistors between pin 1-6 and pin 1-5, I enabled wbo2 heater and waited till the W changed into a P on page mlp07 but no O2 reading showed! Then I measured with DVM across ground and pin1 = 4,57V. Because it should be around 4.41V I changed wbo2_nernst_dc_target=9C into 99 and restarted the board but nothing changed(still 4.57V)? Air calibration wbo2_calibration=DA when O2% shows 20.9
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.