###### ## ## ## ## ##### ## ####
##### ## ## ## ## ## ## ## ##
______ | _ \ | | | | | | | | | |/ / |___/
_ __ | | / / | |/ / | \ | |\ \ \_| \_/
IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now. Visit Preferences to set your user name Summary of change: '''White cossi''' *my setup: standard setup except: injectors: 50.0 lb/hr 525cc/min @ 3bar ford coilpack (wasted spark) *my config: primep=1E primep_temp_scaling=00 shiftcut_time=01 softrpm_rpm=46 cwl=C8 cwh=78 cranking_thres=03 awev=64 awev_temp_scaling=80 awec=2A warmup_clt_range[0]=00 warmup_clt_range[1]=15 warmup_clt_range[2]=27 warmup_clt_range[3]=3D warmup_clt_range[4]=4E warmup_clt_range[5]=64 warmup_clt_range[6]=76 warmup_clt_range[7]=8C warmup_clt_range[8]=AA warmup_clt_range[9]=C8 warmup_clt[0]=BD warmup_clt[1]=B9 warmup_clt[2]=B4 warmup_clt[3]=AD warmup_clt[4]=A1 warmup_clt[5]=8F warmup_clt[6]=84 warmup_clt[7]=7A warmup_clt[8]=6F warmup_clt[9]=64 warmup_rpm_scale=DE req_fuel=64 divider=01 alternate=03 injopen=00 battfac=0D kpafac=96 kpaoffs=94 injocfuel=00 injrampup_battfac=FF injpwm=FF injpwmt=FF als_launch_input=CC rpmk[0]=0B rpmk[1]=B8 tpsdot_kpadot_conf=00 tpsdotrate[0]=05 tpsdotrate[1]=0E tpsdotrate[2]=20 tpsdotrate[3]=40 tpsaq[0]=01 tpsaq[1]=01 tpsaq[2]=01 tpsaq[3]=01 als_cut_mintps=6E tpsasync=01 acmult=E6 tpsacold=14 launch_enrich=00 launch_retard=00 overrun_fuelcut=46 overrun_fuelresume=45 rev_limit=44 airden_ignore=62 config11=31 config12=30 config13=06 batt_cal=C1 fastidle=90 als_max_cut=06 dbaro=0C tps_low=00 tps_high=A0 fan_temp=E3 fan_hyst=05 fan_channel=07 iac_step_seq=C9 iac_conf=08 iac_max_steps=FF iac_tps_thres=3D iac_cold_idle_temp=A2 iac_warm_idle_temp=90 iac_cold_rpm=78 iac_warm_rpm=55 iac_cold_start_pos=FF iac_warm_start_pos=FF iac_afterstart_rpm=0A iac_afterstart_duration=20 iac_speed=09 iac_kp=0A iac_ki=01 iac_kd=0D launch_rpm=28 iac_integral_limit_dec=0A iac_integral_limit_inc=6E iac_integral_deadband=0A iac_deadband=05 als_cut_maxtps=87 iac_overclose_interval=0A iac_ref_pos[0]=52 iac_ref_pos[1]=4D iac_ref_pos[2]=47 iac_ref_pos[3]=45 iac_ref_pos[4]=3B iac_ref_pos[5]=33 iac_ref_pos[6]=0D iac_ref_pos[7]=0D iac_ref_pos[8]=1A iac_ref_pos[9]=0D iac_sol_channel=40 iac_ign_slope=10 softrpm_range=FF iac_ign_advance_limit=10 iac_ign_retard_limit=18 iac_ign_threshold=08 ego_conf=06 ego_lag=02 ego_coolant=90 ego_maxtps=FF ego_maxmap=FF ego_minrpm=0F ego_maxrpm=FF ego_warmup=01 ego_lean_limit=0D ego_rich_limit=0D ego_pid_kp=40 als_enrich=05 ego_delta=03 ego_target=19 ego_pid_window=FF wbo2_warmup_ramp=A0 als_react_tps=66 wbo2_abs_limit=E4 wbo2_limit_maxt=A0 wbo2_fallback=B0 wbo2_retry_t=06 als_retard_rpm1=11 als_retard_rpm2=23 wbo2_ri_target=96 wbo2_nernstdc_target=84 wbo2_pump_pw_zero=68 wbo2_calibration=D7 wbo2_heater_pid_kp=46 wbo2_heater_pid_ki=10 wbo2_heater_pid_kd=1A wbo2_heater_pid_ilimit=80 wbo2_pump_pid_kp=15 wbo2_pump_pid_ki=4E wbo2_pump_pid_kd=00 wbo2_pump_pid_ilimit=84 wbo2_ri_confidence_scale=80 knock_conf=00 knock_sampling_window=F2 knock1_frequency=29 knock1_gain=40 knock1_integrator=14 knock2_frequency=29 knock2_gain=40 knock2_integrator=14 knock_threshold=FF knock_noise_scale=D8 knock_max_retard=00 knock_default_retard=00 knock_retard_step=00 knock_retard_delay=00 knock_advance_step=00 knock_advance_delay=50 knock_minrpm=FE knock_maxrpm=FF ve_learn_coolant=D8 ve_learn_max_power=FF ve_learn_rpm_scale=1E ve_learn_kpa_scale=1E ve_learn_ego_scale=43 ve_learn_min_weight=4D ve_learn_speed=FF ve_learn_limit=FF ve_learn_conf=00 lcd_c0=FF lcd_delay=FF lcd_backlight=FF kpa_conf=22 als_igncut_rpm2=14 als_retard_mintps=66 als_retard_maxtps=80 lcd_default_view=00 primary_trigger=2F secondary_trigger=19 tooth_wheel=08 trigger_tooth=00 another_trigger_tooth=02 crank_minper=30 tooth_wheel_twidth1=68 tooth_wheel_twidth2=01 cam_sync_r_edge_phase=33 cam_sync_f_edge_phase=46 reset_engphase_after=40 ign_tdcdelay=78 ign_dwell14=2C ign_dwell6=4A ign_crank_advance=20 ign_out=70 ignchmax=03 engine_off_delay=08 pump_on_mintime=08 fuelpump_channel=57 inj_stage2_rate=FF inj_stage2_start_tps=FF inj_stage2_start_map=FF als_igncut_rpm1=11 als_deact_time=37 als_deact_egt=A3 als_retard=3C als_rev_limit=5A misc1out_minrpm=06 misc1out_maxrpm=19 misc1out_mintps=21 misc1out_maxtps=FF misc1out_minmap=50 misc1out_maxmap=FF misc1out_channel=FF misc2out_minrpm=FF misc2out_maxrpm=FF misc2out_mintps=FF misc2out_maxtps=FF misc2out_minmap=FF misc2out_maxmap=FF misc2out_channel=FF act_wot_rpm=FF act_wot_channel=FF act_rpm_rpm=FF act_rpm_channel=FF egt1_cal=4A als_tks_channel=FF boost_conf=89 boost_targetoffs=00 boost_minpressure=41 boost_pid_kp=73 boost_pid_ki=1B boost_pid_kd=FA boost_pid_ilimit=FF boost_channel=48 water_pump_temp=00 hybrid_rpm_a=00 hybrid_rpm_m=00 water_pump_hyst=00 water_pump_channel=FF toothrel_normal=48 toothrel_missing=00 fuelcut_min_kpa=05 fuelcut_max_kpa=69 tach_channel=5F tach_div=10 shiftcut_conf=01 shiftcut_channel=FF h[0]=04 01 02 08 10 00 00 00 h[1]=00 06 04 02 00 06 00 06 h[2]=20 30 20 30 20 30 20 30 Engine starts only with reverse crank sensor polarity. I have a problem with ignition. The timing light shows erratic advance and we can hear it too. When ignition is on (cold ebgine) and the fuel pump is running the egt gauge shows between 26-36Cdegree, otherwise shows the right temp around 23Cdegree. (do wihout the wiring of fuelpump too) '''LOGS''' trigger signal wav: http://www.vems.hu/files/MembersPage/KarolyBakos/triggergut_net.wav *origin record engine starts with megatune log: http://www.vems.hu/files/MembersPage/KarolyBakos/datalog200707292151.xls trigger log: *origin setup (right polarity): http://www.vems.hu/files/MembersPage/KarolyBakos/tooth3_csak%20crank%20eredetipolarit%E1s.txt *crank sensor reversed polarity engine running with: http://www.vems.hu/files/MembersPage/KarolyBakos/tooth4_csak_crank_forditottpolarit%E1s_ezzelmegy.txt Optional: Add document to category: Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.