## 
  #####  
 ##  ##  
 #####   
  ##     
  #####  
 ##  ##  
 #####   

 _   _ 
( ) ( )
| | | |
| | | |
| (_) |
(_____)
       
       

  __  __ 
 |  \/  |
 | \  / |
 | |\/| |
 | |  | |
 |_|  |_|
         
         

  _      
 | |     
 | |     
 | |     
 | |____ 
 |______|
         
         

         
 ####### 
 ##  ##  
    ##   
   ##    
  ##  ## 
 ####### 
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
Sometimes a bit more measurements are needed than usual. The worst is the '''low-toothcount VR.''' * With the 135 tooth audi it's only sectrig that's problematic (and we have very good recipe that works on factory systems and most tweakes systems as well). * with subaru both the primary and secondary VR are the problematic low-toothcount VR: like MembersPage/SkassaSubaruNewtrigger * this page was made after the shocking revelation of the extremely long (and therefore suspicious) MembersPage/SkassaSubaruNewtrigger where 30 deg gap > 90 deg ! Without finding out what is happening, there is little hope. The following measurement is recommended, '''simultaneously''' * soundcard record the '''input VR''' (divide by 10 to 100 should be fine) ** we want to see if the anomaly we've seen in the mde40 log can be seen in this as well ** we accept that the signal is possibly inverted (either both or none). For VR polarity, we have other measurements anyway. * optional: scope record the output of the LM1815 (both channels) * '''Manmde40 triggerlog''' (or with new nightly VT Tools/Triggerlog, save ) with 1.1.78 so we see the sectrig pulses too Than start cranking. We'll syncronise the data if necessary. Take at least 8 seconds. (or 5+5 seconds) ---- '''Until this gets into the nightly''' VemsTune, some executables are here: http://www.vems.hu/filethingie.php?subdir=pacsa * for capturing mde40 log from Tools/Record-Analyze Triggerlog * the '''scope version has realtime update''' ** still a bit crude, but much less keystrokes needed after any HW-change (sometimes just adjusting a potentiometer variable resistor) than earlier. * unzip, and the exe (usually vemsTune-c.exe ) can be dropped into recent, installed nightly vemstune (and make sure to run the vemsTune-c of course).
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.