___  
  / _ \ 
 | | | |
 | |_| |
  \___/ 
        

         
 ##      
 ##      
 ## ##   
 ####    
 ## ##   
 ##  ##  
         

 _______ 
(  ____ \
| (    \/
| |      
| | ____ 
| | \_  )
| (___) |
(_______)
         

_________
\__    _/
   )  (  
   |  |  
   |  |  
   |  |  
|\_)  )  
(____/   
         

 _       
| \    /\
|  \  / /
|  (_/ / 
|   _ (  
|  ( \ \ 
|  /  \ \
|_/    \/
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
Sometimes a bit more measurements are needed than usual. The worst is the '''low-toothcount VR.''' * With the 135 tooth audi it's only sectrig that's problematic (and we have very good recipe that works on factory systems and most tweakes systems as well). * with subaru both the primary and secondary VR are the problematic low-toothcount VR: like MembersPage/SkassaSubaruNewtrigger * this page was made after the shocking revelation of the extremely long (and therefore suspicious) MembersPage/SkassaSubaruNewtrigger where 30 deg gap > 90 deg ! Without finding out what is happening, there is little hope. The following measurement is recommended, '''simultaneously''' * soundcard record the '''input VR''' (divide by 10 to 100 should be fine) ** we want to see if the anomaly we've seen in the mde40 log can be seen in this as well ** we accept that the signal is possibly inverted (either both or none). For VR polarity, we have other measurements anyway. * optional: scope record the output of the LM1815 (both channels) * '''Manmde40 triggerlog''' (or with new nightly VT Tools/Triggerlog, save ) with 1.1.78 so we see the sectrig pulses too Than start cranking. We'll syncronise the data if necessary. Take at least 8 seconds. (or 5+5 seconds)
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.