##  ##  
 ####### 
 ####### 
 ## # ## 
 ##   ## 
         

         
     ##  
     ##  
  #####  
 ##  ##  
 ##  ##  
  #####  
         

         
         
 #    #  
 #    #  
 #    #  
  #  #   
   ##    
         

         
         
 ### ##  
 #  #  # 
 #  #  # 
 #  #  # 
 #  #  # 
         

      _ 
     | |
  _  | |
 | |_| |
  \___/ 
        

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
* GenBoard/Manual/InputTrigger * InputTrigger/TriggerLog (and [https://vems.hu/vt/help/main/tools/triggerlog.html VT Help triggerlog]) As for any projects, start by detailing the setup and wiring on project page made from MembersPage/VAG according to MembersPage We will check that ECU (serialnumber not mentioned, no information, waste of time) has HALL type trigger (or at least sent out with HALL/HALL primary/secondary trigger setup, any later mods we might not know about ). If ECU has VR type trigger input, problems can be expected with HALL signal connected (will not ruin it, but not reliable either). Verify the 5V supply. It can be configuration problem also. vemcfg (and vemslog also a good idea, with notes on the project page about circumstances and what are the associated symptoms). You might need to use oscilloscope to see the trigger signal. Ground problems can cause all sorts of problems (trigger problems, damage, etc...). Always the first to check carefully. GenBoard/Manual/GroundConnections If you need technical help, always refer to your project page. We will review your project page carefully, so provide details about setup and wiring and configuration and device serialnumbers, measurements, etc... (project page is optional, but required if tech help is needed). Refer to RPM signal and "wheel speed" signal. (not "speed signal", that can be either). I hope that helps, regards, Katalin On 2023. 10. 04. 8:36, chr.reidinger@gmx.at wrote: > Hello, > This is the second time I've had problems with a 60-2 trigger flange on the crankshaft. > Part number of the flange 030103171K and Sonsor is a Bosch Hall sensor 0261210215.
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.