__     __
 \ \   / /
  \ \ / / 
   \ V /  
    \_/   
          

 _ 
(_)
| |
| |
| |
(_)
   
   

         
   ##    
 ######  
   ##    
   ##    
   ##    
    ###  
         

         
         
  ####   
     ##  
  #####  
 ##  ##  
  #####  
         

___  ___
|  \/  |
| .  . |
| |\/| |
| |  | |
\_|  |_/
        
        

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
'''Firmware config for trigger''' family, '''where we sync on the short gap''' (instead of the missing tooth bigger gap): examples: * InputTrigger/SubaruTrigger 55 + 93 + 32 degrees * MembersPage/FiatStilo 60 + 90 + 30 * MembersPage/AttilaSzucs As you see, we neglect longer gaps (150 .. 200% relative), and trigger on the shorter gap (appr 30 .. 34% relative). '''Primary trigger settings''' * primary_trigger=29 (decimal 41) that is: ** multitooth (bit1=0) ** multitooth advanced filter ON ** fiatstilo bit ON ** rising edge * multitooth advanced filter (you can tweak this): ** missing tooth: 125 .. 300% ** normal tooth: 16 .. 75% * tooth_wheel=02 '''secondary_trigger''' If you have a distributer, disable (secondary_trigger=02). Without distributer, camsync is needed! GenBoard/Manual/InputTriggerCamSync '''secondary_trigger=5B''' (decimal 91) ** that is strig_camsync, coil type, rising edge ** filter OFF ** fiatstilo (might not matter) <code> uint8_t secondary_trigger; // trigger2, bit0 0:falling/1:rising, bit1 0:enable/1:disable, bit2 1:filtering, bit3 0:toothwheel/1:coil, bit4 0:alien advance/1:cam sync, bit5 1:both edge at cranking bit6:fiatstilo </code> '''Tricks:''' * trigger_tooth=00 # currently neglected, use 00 for compatibility * another_trigger_tooth=03 # for subarutrigger The another_trigger_tooth refers to the cam_counter, that is we cam_sync after the 3 consecutive camtooth seen (see InputTrigger/SubaruTrigger). Set to 01 if you only have 1 camtooth. ---- '''No surprise (4 cyl)''': * ignchmax=03 # for 4cyl * Wasted spark is recommended, eg h[2]=02 03 02 03 .., * rpmk[0]=0b # for 4cyl * rpmk[1]=b8 # for 4cyl
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.