_ _ | | | | | |_| | | _ | | | | | \_| |_/
____ | _ \ | |_) | | _ < |_| \_\
_______ ( ___ ) | ( ) | | | | | | | | | | | /\| | | (_\ \ | (____\/_)
___ / _ \ | | | | | |_| | \___/
### ## ## ##### ## ## ## ## ######
IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now. Visit Preferences to set your user name Summary of change: === Honda F20 === From the S2000, this is now a popular engine conversion into older cars and Lotus 7 replicas as it is an RWD engine. http://img.photobucket.com/albums/v233/sportcarae/s2000%20swap%20pics/P1017888.jpg There are 12 equally spaced teeth 30 degrees apart, with an additional tooth positioned ~20degrees after one (~10degrees before the next). The engine turns clockwise (apparently this is the only Honda VTEC engine that does) so the trigger pattern is: ..., 30, 30, 10, 20, 30, 30, ... Suggesting that this trigger cannot be used with InputTrigger/ShortGapTrigger (See below) It does look as if the trigger could be turned over and refitted which would give the pattern: ..., 30, 30, 20, 10, 30, 30, ... Which might make the missing tooth setup work correctly. ----- did you try with missing tooth setup * if gaps are 30,20,10,30 (in this order) ** try a '''simple missing tooth setup''' ** since 10=>30 is more than 1.5 x even multitooth advanced filtering is not needed ** another_trigger_tooth=06 (if 4 cyl) If gaps are 30,10,20,30 than a variation of InputTrigger/ShortGapTrigger that is not yet supported, I think (because it would also require shortgap at the next event to be fired, 180 degrees later in a 4cyl) Optional: Add document to category: Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.