_____ 
|_   _|
  | |  
  | |  
  | |  
  \_/  
       
       

 ##      
 ##      
 #####   
 ##  ##  
 ##  ##  
 ##  ##  
 ##  ##  
         

         
   ##    
         
  ###    
   ##    
   ##    
  ####   
         

         
         
 ##  ##  
 ##  ##  
 ##  ##  
  ####   
   ##    
         

__   __
\ \ / /
 \ V / 
  \ /  
  | |  
  \_/  
       
       

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
Subsection of GenBoard/VerThree/Testing Only disassemble an ECU if really needed. Many tests can be done by measurement (with the help of VemsTune output menus, test mode=ON). For some operations it's enough to remove endplate only. Typically the following subcircuits can be reached through the endplate: * MAP * TPS * CLT * MAT ** including the MAT pullup resistor (which can be piggybacked 2700 x 510 = 430 Ohm for AAN / 3B factory PTC) * knock * SD-card * FETdrivers ---- '''In rare cases, if disassembly is justified''' If you unclamp the TO220 FETs, and disassemble the ECU, assemble with care: '''make absolutely sure that insulatorsheet is undamaged and neighbor FETs don't touch.''' When ECU unpowered (or even disconnected from the harness, measurement can be done with a few econoseal pins or alligator clips), '''injector outputs should NOT be connected to any other injector output.''' '''Verify this with DVM diode or beep mode measurement.''' This would be 8*7/2 = 28 measurements if done naively (or actually 36 to also measure connectivity to case: which is also NOT desired). Knowing neighbor traces, the '''official procedure, with a small trick: EC36/21 + case preconnected it's only 15 measurements:''' <code> EC36/6 .. EC36/17 EC36/6 .. EC36/18 EC36/6 .. case + EC36/21 EC36/7 .. EC36/18 EC36/7 .. EC36/19 EC36/7 .. case + EC36/21 EC36/8 .. EC36/19 EC36/8 .. EC36/20 EC36/8 .. case + EC36/21 EC36/9 .. EC36/20 EC36/9 .. case + EC36/21 EC36/17 .. case + EC36/21 EC36/18 .. case + EC36/21 EC36/19 .. case + EC36/21 EC36/20 .. case + EC36/21 </code> Measure with DVM diode or resistane (2kOhm) mode: '''there should be NO connectivity''' * Beeping or <300 mV or <300 Ohm shows short / connectivity => bad
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.