##   
   #  #  
   #     
 #####   
   #     
   #     
   #     
         

         
|\     /|
| )   ( |
| |   | |
| |   | |
| |   | |
| (___) |
(_______)
         

   ____ 
  / ___|
 | |    
 | |___ 
  \____|
        

         
         
 ### ##  
 #  #  # 
 #  #  # 
 #  #  # 
 #  #  # 
         

  ______ 
 |  ____|
 | |__   
 |  __|  
 | |     
 |_|     
         
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
[http://megasquirtavr.sourceforge.net/manual/Basics.Install.Mechanic.html [Manual: Basics.Install.Mechanic]] Soldering steps reminder list. '''Before mintest''' * big black barrell inductivity (0.1uH 5.4A) * quartz 16MHz * main fuse wire * 0 Ohm resistor on the bottom * R154 under the atmega * LCD supply capacitor (C89) 10uF * Big Vbatt capacitor (C72) 10uF (min.25V) 1210 * Big 18V 1.5kE18 troughole transient suppression diode (bottom of the board) * connect the GND bridge * pinheaders for the ISP * do the firmware things and checks '''Mintest possible''' at this point * ... * supply voltages * supply current * LCD test requires special connector (since no header) or a bit of experience '''Optional stuff below''' * 5V1 protecting zener for trigger1 D14 * 5V1 protecting zener for trigger1 D27 * configure trigger1 to VR (2 jumpers) * configure trigger2 to HALL (1 jumper) * trigger1 pullup resistor REMOVE (R55) * EC connectors * flyback diodes * flyback airwire (EC36 pin23) * additional GND5 airwire (EC36 pin22) * FETs * IGBT * flyback testing: all inj. outputs toward the flyback rail '''airwires to EC18''' * knock * RS232 * MAP signal (if not onboard MAP) * hotmelt '''Stepper''' * stepper chip * stepper capacitor (C75) 1210 (min.25V), 10uF * stepper Vbatt wire in the place of D45 '''knock''' * 4 MHz * TPIC8101DW knock chip '''for LCD that likes -3V contrast''' * R112=2k4 * take out the 1k towards GND '''Final tests''' * many * pump- voltage * wbo2_pump_pw_zero * wbo2_pumpdc_target Back to GenBoard/Manual
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.