# ###   
 ##   #  
 ##   #  
 # ###   
 #       
 #       

 _   _ 
| | | |
| | | |
| | | |
\ \_/ /
 \___/ 
       
       

         
         
 ##  ##  
 ######  
 ######  
 ##  ##  
 ##  ##  
         

         
         
 ######  
     #   
   ##    
  #      
 ######  
         

         
         
 ##  ##  
 ##  ##  
 ##  ##  
  ####   
   ##    
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
While * (NFET, injector, ignition IGBT, ...) low-side output switches use common cathode flyback to +12V * high-side (PFET) output switches use common anode flyback to GND Tests before ECU powerup, retest after ANY change around the injectors or supply/GND: With ECM connected, but output load (solenoid) NOT, measure the flyback integrity with DVM at the solenoid connector. Low voltage flyback (almost always used, eg. for +4 PFETs) '''measures appr. 500..1500mV in DVM diode mode (with DVM+ red probe at GND).''' Very quick test, touch each PFET high-side switch output pin to verify, take note. Test flyback path integrity for every high-side and low-side output that will (or might ever) be connected. ---- '''See also:''' * GenBoard/Manual/Flyback/Testing
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.