#### ### 
 ##   #  
 ##   #  
  ## #   
  ###    
   ##    
         

 _____ 
/  __ \
| /  \/
| |    
| \__/\
 \____/
       
       

         
     ##  
         
     ##  
     ##  
     ##  
     ##  
  ####   

   ____ 
  / ___|
 | |    
 | |___ 
  \____|
        

     ### 
  #####  
 ##  ##  
 ##  ##  
 ##  ##  
 ##  ##  
  ### ## 
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
We need to add detailed description of sensors and configuration parameters here. Most can be had from GenBoard/InitialConfig page. ---- '''GenBoard/VerThree knockdetection HW''' '''Needed for Knock Sensor input:''' :R1, R2 Knock Channel 1 (10..22k) (analog signal amplitude gain can be adjusted with these; but also in the digital domain - in config) :R3, R4 Knock Channel 2 (same as R1,R2) :R17 1M :C1 Knock Channel 1 (100nF) :C2 Knock Channel 2 (same as C1) :C14 0.22uF :C16 100nF :C18, C19 22pF :Y2 4MHz XTAL (16MHz might work with matching config) :U5 TPIC8101DW (not in rescue kit! Optional, see WebShop) C17 is no longer used. (was: 2.2nF, can now be left off) V3.2: if you ordered knock-kit (in same order as genboard) than U5=TPIC8101DW and Y2=crystal already soldered onboard (crystal missing on a few boards sent out before 20041030.) ---- The kcock sensor chip installation: Pin 1 points to the connectors-side. (so pin 1 points to the short side of the board) The crystal goes next to the chip. ---- '''See also''' * DetonationDetection/LogAnalysis * DetonationDetection * Back to GenBoard/Manual/ConnectingSensors * Back to GenBoard/Manual
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.