####   
 ##      
 ##      
 ##      
  ####   
         

 _ 
(_)
| |
| |
| |
(_)
   
   

 ###     
  ##     
  ##     
  #####  
  ##  ## 
  ##  ## 
 ###  ## 
         

  _  __
 | |/ /
 | ' / 
 | . \ 
 |_|\_\
       

           
     /\    
    /  \   
   / /\ \  
  / ____ \ 
 /_/    \_\
           
           

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
[http://megasquirtavr.sourceforge.net/manual/Detailed.Output.Flyback.html#Tune [Manual: Detailed.Output.Flyback.Tune]] ---- '''Warning''' Don't apply MegaManual's 75% "PWM Current Limit %" ("PWM DC %" or PWM duty)recommendation. 75% is suitable for a remarkably bad flyback design (with flyback return 30V referenced to GND5), that dissipates extreme heat with PWM-ing and induces high voltages, should the injector fuse break. The circuit breaks regularly because of overheating (usually the clamping PNP breaks, sometimes the FETs). ---- '''Example calculation for PWM DC%''' (dcpercentage): Iinj * Rinj = VBatt * dcpercentage/100 - Uflyback * (1-dcpercentage/100) From this, for Iinj=1A and Rinj=3Ohm, with some primary-school math: * 3V = 14.5V * x - 5.5V * (1-x) * 3V = 14.5V * x - 5.5V + 5.5V * x * 3V = 20V * x - 5.5V * 8.5V = 20V * x * x = 0.425 (which is for dcpercentage=43% ) Verification: at Uflyback = 5.5V and PWM DC=43% you get 1.03 A: 1.03 A * 3 Ohm = 3.1V = 14.5V * 0.43 - 5.5V * (1-0.43) ---- '''Measurement''' When you measure injector current: * take care not to open the flyback path. This is very important * take out the fuse, and measure there ** either 20A DC mode ** or 1 or more 0.1 Ohm 5W resistors in parallel: in this case 2V DC voltage (not current!) mode * take care not to kill yourself * the injector pulsewidth (or injector duty: beware, it is very different from injector PWM duty!) must be included in the calculation ---- Back to GenBoard/Manual/Flyback GenBoard/Manual
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.