######  
    ##   
   ##    
  ##     
 ######  
         

         
         
  ####   
 ##      
 ##      
 ##      
  ####   
         

  _     
 | |    
 | |    
 | |___ 
 |_____|
        

         
         
 ##  ##  
 ##  ##  
 ##  ##  
  ####   
   ##    
         

         
         
  ### ## 
 ##  ##  
 ##  ##  
  #####  
     ##  
 #####   

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
'''Injector Timing''' (Injector Angle tune) ---- The injection end-angle is tunable from Firmware 1.1.80. To disable this function use 720 degree everywhere. '''Always set 720 deg for all channels when no camsync''' (injector angle adjustment requires camsync). For this feature secondary trigger (camsync) is needed. The '''injector angle curve shows the injecting end angle before TDC.''' (assuming the injector outputs match the relevant ignition output). Injector actuation can be set from 210 to 720 degree before trigger tooth depends by Injector Angle curve. (lower than 210 is possible by rotating the injector output table, eg. by -180 deg or -120 deg for 4/6 cyls. But it matters little anyway to inject on closed valve or closed valve). This feature is only avaliable to Primary injectors ( Staging injectors can not be delayed ). The injector stop moments are tunable, but the minimum injector start moment is at trigger tooth. If injector pulse width is higher then the configured delay, the injection starts at trigger tooth (not earlier), so the injector end-angle gets somewhat delayed. * This happens above appr 60% injector duty with injendangle=288 setting * or above 93% injector duty with injendangle=48 setting (for a 6 cyl this is actually 288 deg after rotating injector outputs by 2 positions, = 2*120=240 deg). But it matters little anyway to inject on closed valve or a closed valve Suggested value for new installs is between 210 and 370 degree BTDC.
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.