##  # ## 
##  #  # 
 ## ## # 
 ### ##  
  ## ##  
  #   #  
         

__   __
\ \ / /
 \ V / 
  \ /  
  | |  
  \_/  
       
       

         
         
  ####   
     ##  
  #####  
 ##  ##  
  #####  
         

         
         
 #####   
 ##  ##  
 ##      
 ##      
 ##      
         

         
         
 ##  ##  
 ####### 
 ####### 
 ## # ## 
 ##   ## 
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
'''Wheel Speed''' Measurement of wheel slip. Requirement of at least one additional hall channel, possibly up to a total of four(including the previous speed sensor), one for each wheel. Needs the addition of at least four additional hall / VR sensor input and conditioning. One per wheel, and possibly multiple driveshaft and gearbox speed sensors as well. Worst case scenario: Crankshaft, camshaft, front and rear driveshafts, and four wheels. The Bunderson would ideally require two hall sensors, one front, one rear. I purposely reduced the number of hall input requirements so that the Genboard would still function as an ECU without a daughter board being created. Fair enough. I was thinking of my own truck here, but lets keep it simple to start with. Should we not then extend the Genboard project with a daughter board?
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.