####   
 #    #  
 ######  
 #       
  ####   
         

         
         
  ####   
 ##  ##  
 ######  
 ##      
  ####   
         

 __      __
 \ \    / /
  \ \  / / 
   \ \/ /  
    \  /   
     \/    
           
           

   ##    
         
  ###    
   ##    
   ##    
   ##    
 ######  
         

         
|\     /|
| )   ( |
| | _ | |
| |( )| |
| || || |
| () () |
(_______)
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
Cheap project. Engine: *Stock 2.3 NA bottom end *20v 7A NA head *AAN intake *stock manifold *KKK K24 turbo *TFSI COP *1 window distributor *60-2 vag wheel trigger *wiring harness from 7A 20v engine ---------------------------------------------------- I have problem about vag 60-2 wheel (hall effect). The trigger cable is shielded. Pinout: pin1: 5V pin2: signal pin3: signal GND (wired to chassis gnd) The voltage on PIN1 is 5.01V ignition on but during cranking i measured 6-7V. Is it normal? This is a screenshot about primary trigger signal. http://www.vems.hu/files/tbiro/20_ghetto/trigger_error.jpg
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.